270 degrees rotate from 0.5 m to infinity. Plastic gear 0.8 include. (made on 3d printer) installed! 3 way for assemble scope for choice.Please select one from: 15-60 support, clamp for you attachment (also possible clamp ajutable rods support -please look photos 9). Clamp I make to order according to your measurement and filter thread 72,77,82, 67 for choice.
Include lot one for choice. Covarage : 58 mm lens 1.5 crop factor (2.35x1 post) with Schneider cinelux 2x without vignetting. Test footage with cinelux 2x.
If you use any baby scope whose outside diameter less 58 mm. Possible attachment push inside module.
Than vignetting will be significantly less. Best use if it reduces the outer size of the scope to 58 mm and install inside the module. In order to bring the scope glass closer to the rear glass of the module.To do this, in principle, it is enough to remove the top ring of such attachments as a sankor 16c and simply fix the scope to infinity with tape. Please look photo 11,12 - Nut for computer mother board and bolt m3. Form an emphasis for infinity, also please look video instruction.
This footage with sankor 16c inside module. On sale, all as is shown in pictures. If there will be questions, please write me. I will try to answer all your question.
The item "Kolner Single Focus Run and Gun Long (RNGL) for anamorphic" is in sale since Tuesday, August 25, 2020. This item is in the category "Cameras & Photo\Lenses & Filters\Lenses". The seller is "anamorphic_ru" and is located in Moscow. This item can be shipped worldwide.